Friday, October 4, 2019

Lab report Example | Topics and Well Written Essays - 1250 words

Lab Report Example This provided input or output voltages of -10V to +10V. 2. Connect the BNC cable, shown in Figure 2 below, to Thermistor/Pressure EX J17 on the signal condition ‘pizza box’ on the side of computer cart to the pressure transducer interface box BNC connector labeled â€Å"Excitation†. 3. Capture the signal generated by the pressure transducer. Connect the Thermistor /Pressure output signal to J8 that has an SCC-FTO1 module that acquired the analog voltage and pass it into data acquisition System. 2. The instrument had a linearity of 0 .1 0 0 6, hysteresis 0.0 0 8 0 and combination of 0. 1 0 0 6 as shown in the above table 2. Maximum amplitude found on the CRO was 0.9and minimum at 0. 1 at time 0.0 0 and 1. 0 m respectively as shown in figure 6 below. Some of the data obtained deviated due to change in the environment temperature affecting the pressure of the area. This was rectified by performing the experiment under controlled environment of controlled pressure and

No comments:

Post a Comment

Note: Only a member of this blog may post a comment.